22/09/02

Installation methods of speed reducers and their working principle

Among the family of gearboxes, the cycloid reducer is widely used in servo, stepper and DC transmission systems for its small size, high transmission efficiency, wide range of reduction and high accuracy.

Among the family of gearboxes, the cycloid reducer is widely used in servo, stepper and DC transmission systems for its small size, high transmission efficiency, wide range of reduction and high accuracy. The correct installation, use and maintenance of the gearbox is an important part of the normal operation of machinery and equipment. Therefore, when installing the planetary gearbox, please be sure to strictly follow the following installation and use related matters, carefully assembled and used.

First, confirm whether the motor and reducer are intact before installation, and strictly check whether the dimensions of the parts connected to the motor and reducer match, here are the dimensions and fitting tolerances of the motor's positioning boss, input shaft and reducer recess, etc.

Secondly, screw down the dustproof hole on the outside of the reducer flange, adjust the PCS system clamping ring so that its side holes are aligned with the dustproof hole and insert the hexagonal screw. After that, take away the motor shaft key.

Third, connect the motor to the gearbox naturally. When connecting, ensure that the output shaft of the reducer is concentric with the input shaft of the motor and that the outer flange of both is parallel. If the concentricity is not consistent, it will cause the motor shaft to break or the gears of the gearbox to wear out.

Before connecting the motor to the reducer, the motor shaft keyway should be perpendicular to the tightening bolt. During installation, hitting with hammers etc. is strictly prohibited to prevent excessive axial or radial forces from damaging the bearings or gears. Be sure to tighten the mounting bolts before tightening the tightening bolts. The correct installation between the reducer and the mechanical equipment is similar to the correct installation between the reducer and the drive motor. The key is to ensure that the output shaft of the reducer is consistent with the concentricity of the driven part of the shaft.

其他资讯

NO CONTENT